Vietnam 300mm red yellow green traffic light and pedestrian light

Vietnam Vietnam 300mm red yellow green traffic light and pedestrian light

The parameters of the Vietnam 300mm red yellow green traffic light and pedestrian light:
Product model: WDM-JD300-3-RYG
1. Product size: 1050*350*110mm (without decorative edge)

pedestrian light size:700*350*110MM

2. Number of lamp beads: 156 red, yellow and green       pedestrian light:65pcs reds, 120pcs greens
3. Lightning diameter: 300MM
4. Lamp Beads Category: Taiwan Crystal Chip Lamp Beads
5. Red wavelength: 620-625NM
6. Yellow wavelength: 590-595NM
7. Green wavelength: 500-505NM (blue-green) 520-525NM (green)
8. Service life: 100000H
9. Shell material: PC
10. Illumination angle: 30°
11. Working temperature: -40 ° C -65 ° C
12. Protection level: IP53
13. Working voltage: AC85V-265V A small amount of DC12V/24V
14. Rated power: red and yellow each 18W green 22W
15. Installation method: horizontal or vertical
16. Visual distance: ≥1000M

Second, the characteristics of the 300mm red yellow green traffic light and pedestrian light:
1.300mm red yellow green traffic light and pedestrian light use Taiwan crystal chip lamp beads, high brightness, high

refresh rate, long service life.
2.300mm red yellow green traffic light and pedestrian light on the back of the design of the outlet hole, not only easy to

outlet, but also has a good waterproof effect.
3.300mm red yellow green traffic light and pedestrian light sunshade is made of PC material, which has better waterproof

and dustproof effect and simple installation.
4.300mm red yellow green traffic light and pedestrian light each of the lights and lights with a snap-on design, convenient

for product inspection and maintenance.

300mm red yellow green traffic light and pedestrian light installation method:
Installation method: horizontal installation
1. Leave a screw on both ends and unscrew the nut on the screw.
2. Place the “L” bracket on the flat end and tighten the nut according to the hole position and the slot on the screw. (as the

picture shows)
3. The sun visor is installed on the upper part of the lamp. The three-corner aluminum plate is folded into a circular arc

shape, which is placed on the lamp and screwed to the corresponding hole to tighten.
4. Make 2 holes on the signal light rod, drill holes according to the hole position of the L bracket of the signal, pass the light

rod through the appropriate screw, and put the L-shaped bracket on the screw and fix it with the nut. (as the picture shows)
Installation method: erect installation
The same steps as erecting and traversing, just stand upright,
Pay attention to 2 o’clock,
1. The sun visor is on the upper part of the lamp 2. The outlet hole is facing down (as shown)

300mm red yellow green traffic light and pedestrian light connection:
1. Power up AC220V:
The black line is the public zero line;
The red line is a red light line;
The green line is the green light line;
The yellow line is the yellow light line;

If you are interested in our product,Please fell free to contact with us