Production process of Round Shape Plastic Solar Road Stud:
The Round Shape Plastic Solar Road Stud is a very beautiful landscape LED light. It is a round plastic case that looks like a
plastic flying saucer. It is very beautiful. The light can be 6 LEDs. The average distribution can also be an average distribution
of 8 LEDs, or it can be an average distribution of 10 LEDs.
The production process of Round Shape Plastic Solar Road Stud is a bit complicated. Let’s take a closer look.
1. The circular plastic road stud shells of the solar panels will be selected, and the output voltage of each solar panel will be tested.
With its output current, it will be tested with the instrument to ensure that the LED solar panels are good, QC quality control, The
solar panel shell, there is no scratch, there is no damage, there is no deformation, all tested well.
2, The Round Shape Plastic Solar Road Stud shell, install LED lights, each LED light needs a plastic kit, need to be installed, after
installation,insert the LED light into the plastic kit to ensure the sealing of each LED So that when he is filling the glue, the glue will
not enter the inside of the LED lamp bead.
3. Connect all the LEDs inserted into the round plastic solar spikes so that all the LEDs are connected in series according to the circuit
principle of the design. In the middle of this detail, all the LEDs must be soldered firmly to ensure this. Round Shape Plastic Solar Road
Stud that will last longer in the future
4. The driving circuit of the Round Shape Plastic Solar Road Stud is inserted into the whole casing, and the whole driving circuit is divided
into positive and negative electrodes, and the positive pole of the LED is connected with the positive pole of the driving circuit, the negative
pole of the LED and the driving circuit are The negative poles are connected together, and the drive circuit must be ensured in the middle of
this process, so as not to be damaged by static electricity.
5, The battery installed Round Shape Plastic Solar Road Stud, after all the procedures are completed, the battery is installed at the end,
although it is a nickel-hydrogen battery, but the battery is a dangerous product, only the last time can install this battery, Well, after the
battery is installed, it starts to test the function of the entire round plastic solar spike.
6, Will test the semi-finished products of the Round Shape Plastic Solar Road Stud, start filling glue, all products that have been inspected by
QC, after ensuring the correctness, ensure that after the battery has been tested by charge and discharge, all are OK, then start potting This
potting compound uses a completely sealed glue, his time delay is very good, and his pressure resistance is also very good.
7, After you select the round plastic carbon can be nailed, QC will check, the electrical performance will be checked, the appearance will be
checked, the charge and discharge will be checked again, and all the LED, Round Shape Plastic Solar Road Stud products will be placed. The
dust-free space on the roof of the building enters the charging and discharging time of each half-month. After half a month, if there is no
problem with this product, then basically it can be packaged and shipped, all round plastic solar spikes. It has been finished with the finished
product. It has been used for 15 days. Although it is a dust-free environment, it has passed, charging and discharging, and the most important
testing means. The quality of such products will be very good and will be worthy. Purchased customer
The application of the Round Shape Plastic Solar Road Stud:
Recommendations for Led solar road stud:
1, horseshoe-shaped solar road stud
2, double-sided 6-lamp solar road stud
3, single-sided 3 lamp solar road stud
4, Round shape solar road stud, etc.
If you are interested in our product,Please fell free to contact with us
Post time: Jun-20-2019