empty

Instructions about how to install solar road stud

These solar LED road studs are naturally charged by the sun.
As soon as it starts getting dark the LED lights in the stud come
on automatically each night for up to 10 hours. They have been
specifically designed with road safety in mind and can help to
prevent serious accidents and emit rather than reflect light.
Solar LED Road Studs are also known as solar raised pavement markers,
solar reflective lane markers and solar warning devices.

ee8de173ae227b23d188623458907367

Place to Install:
1. Dangerous blind corners and sharp-curves, black spots and poorly lit areas.
2. Areas with unpredictable weather conditions
(coastal roads, foggy areas, wet and rainy regions, etc.).
3.Joint intersections, on and off ramps, center lines and dividers,
4. entrance warnings, carpool lanes, bridges, cross and side walks
4. Guidance lines, traffic islands, roundabouts and mountain roads.
5. Taxiways at airports, bike and pedestrian lanes, aboard ships and watercrafts.
6. Entertainment areas, parking lots, hotel entrances and gas stations etc.

 378a68230420b6d029579462034f0e43

Notice about installation :
• Check if the solar stud charges and discharges normally
• Identify the place for installation
• Clean road surfaces 
• Clean the bottom of the solar stud and use epoxy glue to stick it to the ground
• Wait 8 hours for drying before activating solar stud
• Caution: never installed in the central line
Make sure no vehicles press on the road stud .

01bfd6cb519758b561a5cf0b01bb3601

If  you are looking for such solar road stud ,please contact us freely at fiona@wdm88led.com or lisheng@wdm88led.com 


Post time: Jul-10-2017
INQUIRY NOW
  • * CAPTCHA: Please select the Cup